Description:

2 x 2000 Ton Kurimoto Model C2F-20GW & C2F-GW /TES-60D Hot/Warm Vertical 5-Station Forging presses for Inner and Outer Bearing Races
Built 2008/2012

SPECIFICATIONS:
Built by Kurimoto, Ltd, Osaka, Japan
Capacity 2000ton
Stroke 400mm
Number of strokes 30 – 60min.
Continuous inching: 5 min – 1
Automatic Die height Adj 977mm (stroke down on adj. up)
Slide adjustment 10mm
Max. Part weight 4kgs
Max. Part diameter 180mn
Bolster bottom dimensions (R/L) 1600x (F/R) 1080 x (thickness) 250mm
Bolster top dimensions (R/L) 1600x (F/R) 1080 x (thickness) 150mm
Side opening 1200mm
Distance between columns.2,000mm
Lower Knockout.................Height stroke: 100mm, Diameter: 40mm.
Max. 400kN (total 1Mn x 100mm)
Main Motor.........................268.2HP (200kW)

Including:

Manyo LBS-300 Bar Shear w/auto bar rack and extra cutters, 90mm stroke length, 60spm, overhead crane, load meter, signal tower, Display panel.
Uni-Wash System
Bar Rack & Mitsui 1000kW Induction Heater, 6600 volts, Model HP-PH12-01
Automated NTEC SSP-300I Sizing press for outer rings, built 2012, 200mm length of stroke, Bolster area: 900 x 600mm, Controls with display

FEATURES:
• Load meter with overload sensor
• Revolutionary Stick release device (hydraulic type)
• Automatic 5-Station (3D) servo transfer system
• Bearing temp. detector (8 x locations)
• Guide gib temp. detector (8 x locations)
• Wide range of allowable eccentric loads
• Die holder change device
• Upper die exchange device
• Knockouts
• Oil separator
• Material Feeder
• Strain gauge type load meter w/Digital Display
• Automatic Die Height Adjustment feature
• Smoke extraction system
• Top force changer
• Die holder clamper and lifting device
• Die holder: for top forc
• Die height automatic control unit
• Lubrication cleaning device for press body
• Tool lubrication system
• Flange for Exhaust
• Mitsubishi PLC controls
• Air filtration system
• Spare motor & spare upper and lower bolsters
• Inner, Outer, Web and Bypass conveyors
• Bearing Temperature Sensors at (16) locations
Transfer Machine model TES-60D w/many fine features
• Die Holder Clamper and Lifting Device
For top force - (4) Units for Each press Line
For Bottom Force - (6) Units For Each press Line
Die Lifter One Unit each for RH & LH)
Extra bolsters, Machine parts, oil separator, conveyors
Only small 1.3kg low/medium carbon parts were ever produced on these machines. The presses are capable of going up to 4kgs. They were never abused or used to full capacity or speed.