DMC TECH TUBE MILL LINE YEAR 2007

 

 

Used second hand Tube mill line(3inch x6mm thickness)
Make: DMC Tech (Korea)
Year: 2007
•Cap': Ø76.3×t6.0mm
 •Thickness : 1.8 ~ 6.0mm
 •Line Speed : 12.5 ~ 100m/min
 •Out Dia' : Max. 76.3mm
1) ENTRY PREPARATION SETION
 •Double drums & Swivel Uncoiler
 - Loading Cap': Max. 5.5ton × 2
 - Tension & Brake:Hyd' Disk Brake
 •Coil opener & Leveler
 - Snubber roll
 - Coil opener
 - Level With Pinch Roll
 •Shear End Welder
 - Guide Range : Max. 300mm
 - Shearing
 - Welder : 350 Amp
 •Rotary Accumulator
 - Mill speed : Max. 100m/min
 - Winding speed : Max. 100m/min
 - Spiral drum Dia' : 1,700mm
2-1) ENTRY PART
 •Guide roll
 - Upper Roll Dia' & Width :
        Ø100 × (W)300mm
 - Lower Roll Dia' & Width :
        Ø100 × (W)300mm
 •Side guide roll
- Roll : 4sets
 - Roll Dia' & height :
                Ø75 × (H)100mm
 •Leveler
 - Roll Dia' : Ø70mm
 - Width of Roll : 300mm
2-2) Forming Part
 •Breakdown Driven Roll Stand
 - Roll Root Dia' : 160mm
 - Top/Bottom Roll Root Shaft Dia': 75m
 •Side Idle Roll Stand
 - Roll Shaft Dia' : 60mm
 - Roll Root Dia' : 140mm
 •Fin-pass Driven Roll Stand
2-3) Welding Part
 •Seam Guide Roll Stand
 - Shaft dia' : 45mm
 - Roll Root Dia' : 160mm
 - Rotating Angle : 130˚
 •Squeeze Roll Stand
 - Shaft Dia' : 70mm
 - Roll Root Dia' : 150mm
 •Current Transformer Stand
 •Outside Bead Cutter
   & Bead Winder
 - 2-Head Tanden Tool Type
 - Drive of Winder : 0.4kw
 •Ironing Roll Stand
 •Tube Cooling
- Type : Water cooling
 - Length : 4,000mm
2-4) Sizing Part
 •Sizing Side Idle Roll Stand
 •Sizing Driven Roll Stand
 •Turk's Head
 - Shaft Dia' : 45mm
 - Rotating : 360˚
 •Measuring Roll Stand
 - Roll : 127.324mm Dia
3) Cut-off section
 •Flying cut-off M/C
- Cutting length : 4,500 ~ 9,000mm
 •Double dump run out table
4) End facing & chamfering M/C
 - Pipe : (t) 1.8 ~ 6.0mm
 - Pipe : (L) 4,500 ~ 9,000mm
5) Packing system
 •Chain conveyor
 •Pocket with pusher
 •Chain conveyor
6) Control Panel