CASTAL TWIN ROLL ALUMINIUM CONTINUOUS STRIP CASTER

Used 1350mm Twin-Roll Aluminum Continuous Strip Caster
Manufacture Castal
Cast Strip Width 1350mm max 53.15"
Cast Strip Thickness Maximum: 12.0mm .472"
Minimum: 4.2mm .165"
(4.2mm thickness was achieved by owner)
Casting Speed 1050 alloy = 1.5mton/hr achieved
3003 alloy = 900 kg/hr achieved
Caster Configuration Horizontal, 15 degree tilt
Equipment
- Two Melting/Holding Furnaces 12 mton tilting type, Scrap charge car
- Molten Metal Level Pour System
- Titanium-Boron Grain Refiner Rod Feeder
- Tips 2 sets of tip tables included
Electric tip bake-out oven
Material for 30 hard and 20 soft tips included
- Caster
- Cylinders Hydraulic tilting type
- Drive Siemens DC motor, Single drive type
Flender gearboxes
- Rolls 2 pairs included
660mm diam x 1450mm face
Akers internal H2O cooled type
Bottom shell each set = cracked
Cores = perfect condition
Chocks & bearings included
- Electrics and Controls Siemens PLC and SCADA system
Central control for all system, Drawings included
- Edge Trimmer Not installed but there is space to install a system
- Pinch Roll Stand Hydraulic, Siemens DC motor, Flender gearbox
- Shear Hydraulic traveling type
Fully automatic, Limit switch control
- Strip Feeder Feeds strip into coiler
- Recoiler Hydraulic action, Coil push-off, Coil car
- Other Equipment Included:
- Uninterruptible Power Supply GE system
- Spectrometer Arun type design, 24 channels
- Heat Exchanger Alfa Laval water cooling system
Maintains roll skin temp at 80-85 degrees
Condition
- Very good
- Installed and can be dry-run during inspection
- Maintenance has been diligent
- Decommissioning was done with care